Wireless magnetic door detector
The JA-183M is a component of JABLOTRON system. It is designed to detect the opening of doors, windows, etc. The detector is designed to be installed by a trained technician with a valid Jablotron certificate.
Installation
- Open the detector cover (by pressing the latch fig. 2).
- Screw the rear cover to the solid part of the door/window using holes (1).
- Insert battery to the battery holder (6).
- Mount the front cover onto the rear part, click the latch and secure by locking screw (fig. 1).
- Screw the permanent magnet (4) onto moving part of door/window using holes (2).
Figure 1 a 2: Opening and securing the detector
Figure 3 a 4: Description of the internal parts of the detector
1 – mounting holes of detector; 2 – mounting holes of permanent magnet; 3 – magnet position A, B; 4 – serial number; 5 – reed switch; 6 – battery CR123A; 7 – tamper; 8 – reaction settings (major in control panel);
1 – mounting holes of detector; 2 – mounting holes of permanent magnet; 3 – magnet position A, B; 4 – serial number; 5 – reed switch; 6 – battery CR123A; 7 – tamper; 8 – reaction settings (major in control panel);
Enrolment to the system and settings
Depending on the type of control panel, use the recommended software or application, see the control panel manual.
Technical specification
| Power | lithium battery type CR123A (3.0 V / 1.5 Ah) Please note: Battery is not included |
|---|---|
| Quiescent current consumption | 5 mA |
| Maximum current consumption | 50 mA |
| Low battery voltage | 2.4 V |
| Communication frequency | 868.1 MHz, Jablotron protocol |
| Communication range | approx. 300 m (open area) |
| Dimensions of module | 75 x 31 x 23 mm magnet A: 56 x 16 x 15 mm, magnet B: Ø10 x 4 mm |
| Weight (without battery) | 22.2 g |
| Operating temperature range | -10 °C to +40 °C |
| Classification | security grade 2 / environmental class II (according to EN 50131-1) |
| Environment | indoor general |
| Average operating humidity | 75% RH, non-condensation |
| Certification body | Trezor Test s.r.o. (no. 3025), Anpi |
| Complies with | EN 50131-1, -2-6, -5-3, ETSI EN 300 220, EN 50130-4, EN 55032, EN IEC 63000, EN IEC 62368-1 |
| Can be operating according to | ERC REC 70-03 |
| Recommended screw | 2x  ø 3,5 x 40 mm (countersunk head) |
  | JABLOTRON a.s. hereby declares that JA-183M, JA-183MB are in a compliance with the relevant Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The original of the conformity assessment can be found at www.jablotron.com – Section Downloads. | |
 | Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point. | |
| JA-183M | MLL541006 (14.03.2025) |
|---|