Wireless doorbell button

JA-159J is a component of the JABLOTRON system. Button activation can be used for such functions as a wireless doorbell button, to trigger a panic alarm or to operate various electrical appliances. The button is powered by two batteries, communicates via JABLOTRON wireless protocol and takes up one position in the system. The detector should be installed by a trained technician with a valid certificate issued by an authorized distributor.

Installation

1. Install the doorbell roof onto the selected place.
2. Fit the button to the top of the doorbell roof according to arrow 1 and lock it downwards according to arrow 2 (Fig. 1).

Battery replacement

1. Release the button at the bottom of the doorbell roof and remove it (Fig. 3).
2. Open the button cover with a flat screwdriver (Fig. 2).
3. Unscrew the screw and remove the electronics.
4. Take out low and insert new batteries, screw in the electronics and put on the cover.
5. Place the button back and lock.

Fig. 1: Doorbell roof button lock

Fig. 2: Doorbell opening

Fig. 3: Doorbell removing

Enrollment to the system and settings

Depending on the type of control panel, use the recommended software or application, see the control panel manual.

Technical specification

Power supply	2 x lithium battery, type CR 2032 (3.0 V/0.2 Ah)
Typical battery lifetime	approx. 5 years
Quiescent current consumption	2.6 µA
Maximum current consumption	3 mA
Communication band	868.1 MHz, JABLOTRON protocol
Communication range	approx. 300 m (open area)
Maximum radio-frequency power (ERP)	<25 mW
Operational temperature range	-25 °C to +60 °C
Relative air humidity	75% RH, non-condensation
Dimensions	70 x 30 x 20 mm
Weight	37 g
Dimensions (including the roof cover)	77 x 47 x 28 mm
Weight (including the roof cover)	60 g
Operational conditions according to	ERC REC 70-03
Complies with	ETSI EN 300220-1,-2, EN 55032, EN 50130 4, EN 62368-1, EN IEC 63000
Recommended screw	2 x ø 3.5 x 40 mm (countersunk head)

	JABLOTRON a.s. hereby declares that the JA-159J is in a compliance with the relevant European Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The original of the conformity assessment can be found at www.jablotron.com – Downloads Section.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.