Wireless battery indoor siren

Type: 5SIR2303RJ

The product is a component of the Jablotron systems. It is used for acoustic alarm indication inside the building. For proper functionality, the product must be connected to a control panel that has radio module. Siren must be installed by certificated technic with Jablotron certificate.

Fig. 1: Opening of the device and wall mounting
1 – locking screw; 2 – LED light guide;

Fig. 2: Description of the internal parts of the product
3 – upper latches; 4 – screws; 5 – battery holder; 6 – tamper; 7 – bottom latches;

Installation

1. Remove the bottom cover of the siren by pulling.
2. Screw the back plastic cover into the chosen spot on the wall.
3. Put 3 AA batteries into battery holder. (3) After inserting the batteries, the yellow LED indicator (7) will indicate that siren in not assigned to the control panel by permanent lit.
4. Close the siren cover and secure top cover by locking screw (6) included in package to proper fulfillment of the relevant level of security.

Assignment to the system and settings

According to the type of control panel use recommended software or application – see control panel manual.

Specifications

Power	3x Alkaline battery, type LR6 (AA) 1.5 V/2.45 Ah Batteries are not included in the packaging.
Typical lifetime of batteries	approx. 2 years
LowBatt state	<3,3 V
Quiescent current consumption	135 μA
Maximum current consumption	250 mA
Current consumption during acoustic indication	250 mA
Communication frequency	868.1 MHz, JABLOTRON protocol
Maximum radio-frequency power (ERP)	<25 mW
Maximal acoustic output	85–88 dB
Type of warning device	type W
Dimensions	100 x 67 x 40 mm
Weight (without batteries)	97 g
Classification	Security grade 2/Environmental class II (EN 50131-1)
Environment	Indoor general
Operating temperature range	-10 °C do +40 °C
Average operating humidity	75% RH, without condensation
Certification body	Trezor Test (no. 3025)
In compliance with	EN IEC 63000, EN 50130-4, EN 55032, EN IEC 62368-1, ETSI EN 300 220-1, -2, EN 50131-1, EN 50131-5-3, EN 50131-4, EN 50131-6
Recommended screw	3 x ø 3,5 x 40 mm (flat head)

	JABLOTRON ALARMS a.s. hereby declares that the 5SIR2303RJ product is in a compliance with the relevant Union harmonisation legislation: Directives No.: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU if it is used as intended. The original of the conformity assessment can be found at www.jablotron.com – Section Downloads.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.