Wireless temperature detector

The JA-151TH is a component of the JABLOTRON system. It serves for temperature measurement and forwarding measured data to MyJABLOTRON. MyJABLOTRON analyses and stores measured data for further use for instance activating a selected PG output, the SMS reporting of exceeding temperature limits or to create graphs of measured temperatures. This function depends on connectivity to the JABLOTRON Cloud. This product should be installed by a trained technician with a valid certificate issued by an authorised distributor of Jablotron.

Select the installation place according to the temperature measuring requirements. It is not recommended to install the detector near heat sources affecting measuring (heaters, electric fans, air conditioning outlets, fireplace inserts, etc.). The detector can also be installed in an outdoor environment, but it must be placed into a suitable box with a minimum of IP65 housing, the JA-192PL-A for example.

Installation

1. Open the cover by pushing the latch (1).
2. Screw the rear plastic part to the required place.
3. Insert the battery (5) into the battery holder and close the detector cover.

Figure 1: Description of the internal and external parts of the product.
1 – cover tab; 2 – light lid; 3 – serial number; 4 – activation button; 5 – battery;

Enrolment to the system and settings

According to the type of control panel use recommended software or application – see control panel manual.

Technical specifications

Power	1 x Lithium battery type CR2032 (3.0 V / 0.2 Ah) Please note: Battery is not included
Quiescent current consumption	5 µA
Maximal current consumption	34 mA
Typical battery lifetime	about 2 years
Low battery voltage	< 2.3 V
Communication frequency	868.1 MHz, JABLOTRON protocol
Maximum radiofrequency power (ERP)	< 25 mW
RF range	up to 200 m (open area)
Dimensions	55 x 27 x 16 mm
Weight (without battery)	13 g
Temperature measurement range	-20 to +70 °C
Operational temperature	-20 to +70 °C
Temperature measurement range accuracy	±0.5 °C
Average operating humidity	75% RH, non-condensation
Also complies with	ETSI EN 300 220-2, EN IEC 62368-1, EN 50130-4, EN 55032, EN IEC 63000
Can be operated according to	ERC REC 70-03
Recommended screw	2 x ø 3,5 x 40 mm (countersunk head)

	JABLOTRON a.s. hereby declares that the JA-151TH is in a compliance with the relevant Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The original of the conformity assessment can be found at www.jablotron.com – Section Downloads.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.