Wireless signal output modeule PG

The JA-151N is a wireless component of the JABLOTRON system. It provides an output relay switch. It can be used for switching a door lock, blocking, signalling etc. The relay can be controlled with a programmable control panel (PG) output or according to the status of a section (armed = relay on) or when there is an alarm in a chosen section (alarm = relay on). The device should be installed by a trained technician with a valid certificate issued by an authorised distributor.

Installation

Installation procedure

1. Use switch (6) to set the number of PG output or section to which the relay should respond, see Table 1 and 2.
2. Connect the antenna to the connector (1) and disconnect the jumper (2).
3. Connect the power cable to the terminals (8).
4. Connect the device to be controlled to the terminals (7).

Notes:

• The module can be placed in the JA-190PL mounting box.
• If necessary, an external antenna type AN-80 or AN-81 can be connected to increase the RF range.
• The range of switch settings always depends on the number of sections and PG outputs of the control panel.

Figure 1: module description
1 – external antenna connector; 2 – antenna jumper; 3 – yellow LED indicator; 4 – red LED indicator; 5 – learn button; 6 – DIP switch; 7 – relay terminals; 8 – power terminals;

Table 1: The relay reacts to the state of the section

Table 2: The relay reacts to the PG output state

Enrollment to the system and settings

Depending on the type of control panel, use the recommended software or application, see the control panel manual.

Technical specification

Power	12 V DC (10…30 V)
Communication frequency	868.1 MHz, JABLOTRON protocol
Maximum radiofrequency power (ERP)	<25 mW
Maximal power consumption	35 mA
Quiescent power consumption	18 mA
Contact rating:
Maximum switching voltage	50 V AC/ 60 V DC
Resistive load (cos φ = 1)	max. 2 A
Minimum switching current	10 mA
Dimensions	82 x 50 x 16 mm
Weight	25 g
Average operational humidity	75% RH, non-condensation
Environment	indoor general
Operating temperature range	-10 °C to + 40 °C
In compliance with	ETSI EN 300 220-1, -2, EN 50130-4, EN 55032, EN 62368-1, EN IEC 63000
Can be operating according to	ERC REC 70-03

	JABLOTRON a.s. hereby declares that the JA-151N is in a compliance with the relevant Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The original of the conformity assessment can be found at www.jablotron.com – Section Downloads.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.