Wireless openning magnetic detector mini

The detector is a component of the JABLOTRON system. It is used to detect the opening of doors, windows etc. The detector has an optional reaction (pulse or status). It should be installed by a trained technician with a valid certificate issued by an authorized distributor. Choose a suitable place for the detector’s installation. The electronics should be installed onto the fixed part of window or door and the magnet onto the moving part The detector reacts to the removal of its permanent magnet. The magnet can be installed on the left or on the right side of detector. Avoid direct installation on a metal frame as it may adversely affect the operation of the magnetic sensor and radio communication. If it is necessary to install the detector on metal surface, use the supplied separation plates (1), which can improve both, magnetic sensor functioning and also radio communication range.

Installation

1. Open the detector cover by pushing the tab (3).
2. Screw the rear cover to the door (window) frame.
3. Screw the permanent magnet to the moving part of the door (window). The distance between the electronic part and the magnet should be as small as possible when the door/window is closed. The activation/deactivation distances between the magnet and the detector are shown in the following Figure 1.
4. Enroll the detector to a control panel (receiver). There must be a JA-11xR radio module present in the system for the detector to be enrolled. The enrollment signal is transmitted as soon as the battery is inserted into the detector.
5. When the detector has been enrolled, insert it into the base.
6. Set the detector’s functions. Test the detector’s correct functioning.
7. Follow the manual of the control panel.

Figure 1: Description of external and internal parts of the product
1 – separation plate; 2 – red LED – activation; 3 – cover tab; 4 – serial number; 5 – tamper contact; 6 – battery; 7 – permanent magnet; 8 – magnetic sensor; 9 – red LED – activation; 10 – alternative placement of the permanent magnet;

Assigment to the system

Depending on the type of control panel, use the recommended software or application, see the manual of the control panel.

Technical specifications

Power supply	Lithium battery type CR 2032 (3.0 V/0.2 Ah) Please note: Battery is not included
Typical battery lifetime	cca 2 years (max. 20 activation daily)
Communication frequency	868.1 MHz, protocol JABLOTRON
Maximum radio-frequency power (ERP)	3 mW
Communication range	approx. 300 m (open area)
Dimensions – transmitter part	55 x 26 x 16 mm
Dimensions – magnet part	55 x 16 x 16 mm
Classification	grade 2 according to EN 50131-1, EN 50131-2-6, EN 50131-5-3
Operational environment according to EN 50131-1	II. Indoor general
Operational temperature range	-10 °C to +40 °C
Complies with	ETSI EN 300 220, EN 50130-4, EN 55032, EN 62368-1, EN IEC 63000
Can be operated according to	ERC REC 70-03
Recommended screw	2 x ø 3,5 x 40 mm (flat head)

	JABLOTRON ALARMS a.s. hereby declares that the JA- JA-151M / JA-151MB / JA-151M-AN / JA-151M-GR is in compliance with the relevant European Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU, when used as intended. The original of the conformity assessment can be found at www.jablotron.com – the Downloads section.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.