Wireless PIR motion detector

The JA-150P product is a component of the JABLOTRON system. It detects of human movement in building interiors. Its detection characteristics can be modified by using an alternative lens. False alarm immunity is available in two levels. The detector has a pulse reaction (only reports its triggering), uses wireless communication and is powered with two alkaline batteries. The detector should be installed by a trained technician with a valid certificate issued by an authorized distributor.

Installation

1. Open the detector cover (by pushing the tab 5). Avoid touching the PIR sensor inside (11) – you could damage it.
2. Take out the PCB – it is held by a PCB tab (3).
3. Punch through the holes for the screws in the plastic base and attach it on the wall. The recommended detector installation height is 2.5 m above the floor.
4. Set the Immunity jumper (8) as required – see settings in the full manual.
5. Insert the PCB back, insert the batteries (mind the correct polarity). This is followed by up to three-minute detector stabilization phase indicated with LED indicator flashing.
6. Close the detector cover. To comply with norms, the cover tab must be secured with the supplied screw.

      

Fig. 1: Opening the product and description of internal and external parts of the product.
1 – holes for installing on a flat wall; 2 – holes for installing at an angle; 3 – PCB tab; 4 – holes for installing at an angle; 5 – cover tab; 6 – red detector activation indicator; 7 – battery; 8 – Immunity jumper; 9 – production code; 10 – tamper contact; 11 – PIR sensor

Enrollment to the system and settings

According to the type of control panel use recommended software or application – see control panel manual.

Technical specifications

Power	2x Alkaline battery, type LR6 (AA) 1.5 V Please note: Batteries are not included
Typical lifetime of batteries	about 2 years (the longest lifetime is achieved in smartwatch mode)
Low battery voltage	<2.2 V
Quiescent current consumption	15 μA
Maximum current consumption	50 mA
Communication frequency	868.1 MHz, JABLOTRON protocol
Maximum radio-frequency power (ERP)	25 mW
Communication range	approx. 300 m (unrestricted area)
Recommended installation height	2.5 m above the floor
Detection angle/detection coverage	110 °/12 m (with standard lens)
Dimensions	60 x 97 x 52 mm
Weight (without batteries)	80 g
Classification	Security grade 2/Environmental class II (according to EN 50131-1)
Environment	Indoor general
Operating temperature range	-10 °C to +40 °C
Average operating humidity	75% RH, without condensation
Certification body	Trezor Test s.r.o. (no. 3025), Telefication B.V.
Complies with	EN 50131-1, EN 50131-2-2, EN 50131-5-3, EN 50131-6, ETSI EN 300 220-1,-2, EN 50130-4, EN 55032, EN 62368-1, EN IEC 63000, T 031
Can be operated according to	ERC/REC 70-03
Recommended screw	2 x ø 3,5 x 40 mm (countersunk head)

	JABLOTRON a.s. hereby declares that the JA-150P product is in a compliance with the relevant Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU if it is used as intended. The original of the conformity assessment can be found at www.jablotron.com – Section Downloads.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.