Bus access module with RFID and keypad

The access module is a component of the JABLOTRON system. The product is used to control segments or common segments and modul also works like RFID reader of contactless cards and chip. The device should be installed by a trained technician with a valid certificate issued by authorized distributor.

Fig. 1: Description of external and internal parts of the product
1 – control segment; 2 – segment buttons; 3 – activation button with LED indicator; 4 – keypad module with RFID reader; 5 – latches for module opening; 6 – cover screws; 7 – connector for control segments; 8 – production code; 9 – BUS terminals; 10 – tamper contact;

Installation

When connecting the module to the BUS, always switch the power off.

1. Press the four tabs (5) on the sides one by one and release the module from the plastic base.
2. When installing more control segments, first remove the socket cover on the 1st segment.
3. Remove the transparent plastic cover from the segments (by levering on both sides of the segment near the buttons).
4. Always connect the segment wires to the connector of the previous segment and click them into each other (we recommend coiling the wires by turning the segment by 360° – this will prevent any possible damage to the wires between the plastic parts). Use this method to install all the required segments. Finally push the socket cover in.
5. Push the cable through the plastic base and attach it to the selected place together with the segments using screws. If multiple control segments are required attach them onto the wall using screws as well.
6. Connect the BUS cable to the BUS terminals (9).
7. Connect the segment wires to the internal connector of the keypad (7).
8. Insert the module into the base and proceed according to the control panel installation manual.
9. When you have completed the installation, insert descriptive labels onto the segment transparent covers and close them.

Assigment to the system

Depending on the type of control panel, use the recommended software or application, see the manual of the control panel.

Technical specifications

Power	from control panel bus 12V (9…15 V)
Quiescent current consumption	10 mA
Maximum current consumption	20 mA
Each additional control segment	0.5 mA
RFID frequency	125 kHz
Maximum RFID magnetic field strength	-5,4 dBμA/m (measured at 10 m dist.)
Dimensions	102 x 96 x 33 mm
Weight	150 g
Classification	Security grade 2 (EN 50131-1)
Environmental class	II. indoor general
Operating temperature range	-10 °C to +40 °C
Average operational humidity	75% RH, without condensation
Certification body	Trezor Test s.r.o. (no.3025)
In compliance with	ETSI EN 300 330, EN 50130-4, EN 55032, EN 62368-1, EN IEC 63000, EN 50131-1, EN 50131-3
Can be operated according to	ERC REC 70-03
Recommended screw	4 x ø 3.5 x 40 mm (countersunk head)

	JABLOTRON ALARMS a.s. hereby declares that the JA-113E, JA-113E-GR, JA-113E-AN, JA-113E-WH is in a compliance with the relevant Union harmonisation legislation: Directives No: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The original of the conformity assessment can be found at www.jablotron.com – Section Downloads.
	Note: Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer or contact your local authority for further details of your nearest designated collection point.