Bus outdoor keypad with RFID reader 13,56 MHz

Type: 1KPAD2318LU

The keypad is a component of Jablotron system. The keypad with contactless RFID reader is used to control the alarm system, to activate a PG output and to control access to the building. The keypad features one control segment, a reading surface and optical signalling. The product is suitable for indoor and outdoor use and is powered from the control panel bus. The product is designed for installation by a trained technician with a valid Jablotron certificate.

Installation

Always connect the bus when the system is completely powered off.

1. Unscrew the plastic locking screw (6) and open the keypad cover.
2. Attach the rear plastic of the product to a selected location on a wall so that the spring of the tamper switch (5) can be sufficiently compressed when the installation is complete.
3. Pull the keypad cable through the hole in the rear plastic.
4. Plug the bus cable into the terminal block according to the colours and markings – red terminal +U, yellow A, green B, black GND. For connection outside the guarded area, we recommend using the JA-110T isolator module.
5. Close the product cover and secure it with the locking screw (6).

Fig. 1: description of the external and internal parts of the keypad
1 – red LED – indicates armed status; 2 – green LED – indicates disarmed status; 3 – yellow LED – indicates fault/service; 4 – keypad and reading surface; 5 – tamper switch/contact; 6 – locking screw;

Settings and assignment to the system

According to the type of control panel, use the recommended software or application – see the control panel manual.

Technical specifications

Power supply	from the control panel bus, 12 V DC (8–15 V)
Rated current consumption	15 mA
Maximum current consumption	80 mA
Type of control device	B
Operating frequency	13,56 MHz
Max. RFID mag. field strength	10,37 dBuA/m (3 m)
Compatible RFID cards	NFC, Mifare® Classic, Mifare® DESFire® 4, 7 Byte UID
Dimensions	46 x 151,5 x 25 mm
Weight	196 g
Connection cable length	3,0 m
Operaing temperature range	-25 °C to +60 °C
Relative humidity	75% non-condensing
Environment according to EN 50131-1	IV. outdoor general
Classification	grade 2 according to EN 50131-1, EN 50131-3
Also complies with	ETSI EN 300 330, EN 50130-4, EN 55032, EN 62368-1, EN IEC 63000
Recommended screw	3 x ø 3.5 x 40 mm (half-round head)

MIFARE® is a registered trademark of NXP B.V. NXP B.V. and JABLOTRON a.s. are not affiliated.

	JABLOTRON a.s. declares that the device 1KPAD2318LU is designed and manufactured in compliance with the harmonisation legislation of the European Union: directives No.: 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU, when used as intended. The original Declaration of Conformity is available at www.jablotron.com in the Downloads section.
	Note: Although the product does not contain any harmful materials, do not dispose of it in the garbage but take it to an e-waste collection point. For more information, see www.jablotron.com in the Downloads section.